Lead-acid battery charging connection strips

Lead-acid battery charging connection strips, including T-shaped sliders, T-shaped slots, square collars, cleaning cotton, handles, positioning holes, pins, sealing rings and carrier plates, T-shaped sliders are fixed in the middle of the rear end of the square collars position, the T-shaped slot is set in the middle of the rear end of the anti-bending beam, the square collar is assembled on the outer surface of the anti-bending beam, the cleaning cotton is installed on the inner upper end of the square collar, and the handle is fixed on the middle of the upper end of the square collar. This design realizes the fast cleaning function of the utility model and prolongs the service life of the utility model.
The positioning hole is set on the upper end surface of the positive electrode interface, the pin is fixed on the right side of the lower end surface of the carrier plate, and the sealing ring is installed in the middle of the lower end surface of the carrier plate. , the design realizes the waterproof and dustproof function of the interface, which is convenient for operators to install and disassemble. The utility model has reasonable structure, long service life, good safety, good stability and high reliability.Selecting the correct plating is critical to the success of your connector system. Plating affects connector performance, life cycle, quality and cost.It includes a feeding section, a copper-plating pre-treatment section, a copper-plating section, a tin-plating pre-treatment section, a tin-plating section, a tin-plating post-treatment section and a discharge section which are sequentially connected.
The above-mentioned innovative circuit board electroplating production line capable of concurrently plating copper and tin can improve the shortcomings of the gantry type linear electroplating production line and the circular vertical lifting electroplating line. And it not only has a copper plating process, but also adds a tin plating process, so that two completely different electroplating functions can be simultaneously performed on the same production line, which is a great innovation in the electroplating process of circuit boards.A device for adding copper balls to an electroplating line. The device has a simple structure and is easy to operate. It not only effectively avoids the pollution of the electroplating solution and the waste of copper balls, but also avoids the phenomenon of gaps and holes in the copper ball parts, and improves the electroplating quality.The electroplating process is an important link in the manufacturing process of printed circuit boards. It refers to the process of forming a uniform, dense and well-bonded metal or alloy deposition layer on the surface of circuit boards and other parts using the principle of electrolysis.